Oil loader hydraulic pump should be installed in a coarse filter, and the suction mouth from the tank at the bottom of a certain distance; small loaders should be installed at the outlet of high pressure filter, and the filtration effect should be consistent with the system requirements, to prevent dirt clogging caused by the ......【Details】
Boom cylinder with both ends of the rack and the movable arm is connected with a tilt phenomenon, bearing width is too small, or improper assembly instructions to adjust the clearance between the side wear, bearing width should be increased; the boom cylinder bottom discharge sedimentary material accumulation and boom cylinder......【Details】
Before handling the loader, check that the rod and pin on the machine are fixed in the storage position. The loader cannot turn if it is found that the machine frame is locked. When adding fuel to the loader, be sure to stop the engine. After adding oil, tighten the fuel cap. If oil spills are found, they must be repaired in t......【Details】
The loader working device should be able to guarantee: when the cylinder lock, boom cylinder lifting or landing, the bucket linkage mechanism on translational or near libration, lest the bucket and spilled material; when the movable arm at any position, the bucket arm rotate around the hinge point of unloading, the bucket tilt......【Details】